Multi-Tech ISIHI-2S Spécifications télécharger pdf (Page 133)

MultiModem ISI Hybrid Series, ISIHI-2S/2U 133

Appendix

Appendix E: Configuration Profiles

Quick Setup Factory Profiles

For quick setup, the Terminal Adapter includes four Quick Setup Factory Profiles, each of

which is configured for a specific type of port operation. You can load a Quick Setup

Factory Profile into active memory by using the command &Fn, where n is the number of

the profile you want to load. If you want, you can then customize the profile and store it,

using the &W command so that it loads automatically when the TA is turned on or reset.

These profiles are stored in permanent memory and are not user-configurable as such.

&F0 Profile 0Modem-like asynchronous operation (default)

&F1 Profile 1V.120 asynchronous operation

&F3 Profile 3ML-PPP asynchronous operation

Quick Setup Example

The following procedure assumes you want to load, modify, and store Quick Setup

Factory Profile 2 as your default configuration.

1. Select the profile closest to the requirements of your application, in this case, Quick

Setup Factory Profile 2.

2. In terminal mode, type AT&F2 and press ENTER. Quick Setup Profile 2 loads into

the TAs active memory.

3. Enter any additional AT commands that you need to customize the selected profile to

your application (see Chapter 5, Terminal Adapter AT Commands, S-Registers, Result

Codes).

4. Type AT&W0 and press ENTER to save your customized port configuration.

5. Your customized profile now loads automatically whenever the TA is turned on or

reset.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 187 188

Pas de commentaire

Multi-Tech ISIHI-2S Spécifications Page 133